Appliance Break-In; Heat Management - Heat & Glo 6X-AU Owner's Manual

G. Appliance Break-In
Initial Break-in Procedure
• The fireplace should be run three to four hours
continuously on high.
• Turn the fireplace off and allow it to completely cool.
• Remove fixed glass assembly. See Section 4.
• Clean fixed glass assembly. See Section 4.
• Replace the fixed glass assembly and run continuously
on high an additional 12 hours.
This cures the materials used to manufacture the fire-
place.
Note: Some IPI systems have a safety feature that
automatically shuts down the fireplace after 9 hours of
continuous operation without receiving a command from
the remote control. If this occurs, restart the appliance.
NOTICE! Open windows for air circulation during fire-
place break-in.
• Some people could be sensitive to smoke and odors.
• Smoke detectors could activate.
Heat & Glo • 6X-AU Owner's Manual • 2508-981 Rev. L • 8/22
H. Heat Management
Burn Rate
The 6X-AU model has a variable burn rate which is con-
trolled by the remote control. Therefore the flame height
is adjustable.
The flame height may be adjusted as desired by locating
the flame option on the remote control and adjusting up or
down to desired flame height.
13