Heat & Glo 6X-AU Owner's Manual page 25

Refractory, Grate and Valve Assembly
Removal
It may become necessary to remove the refractory, grate
and valve assemblies. This task should be performed by
a qualified service technician. The refractory, grate and
base refractory do not need to be removed to service the
burner assembly.
Figure 4.3 Side Refractory Removal
To remove the top refractory panel, lift the top refractory
panel up using both hands, slide it forward as much as
possible and carefully lower it.
To remove the side refractory panels, remove the glass
panel side retainers (if glass refractory only), then slide
the panel forward as shown in Figure 4.3. Rotate the pan-
els and remove as shown in Figure 4.4. Remove the back
refractory panel by lifting it over the burner assembly.
NOTICE: Remove refractory before removing grate. If
grate is removed first, damage to refractory could occur.
Heat & Glo • 6X-AU Owner's Manual • 2508-981 Rev. L • 8/22
Note: Refractory is Fragile.
Handle with care.
Figure 4.4 Side Refractory Removal
Note: The refractory must be removed
before removing the grate.
Figure 4.5 Grate Removal
25