Appliance Break-In; Heat Management - Heat & Glo SL-5LP-IFT Owner's Manual

H. Appliance Break-In
NOTICE! Open windows for air circulation during fire-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
Follow the initial break-in procedure below to cure the
materials used to manufacture the fireplace and the
finishing materials around it.
• The fireplace should be run three to four hours
continuously on high.
• Turn the fireplace off and allow it to cool completely.
• Remove fixed glass assembly. See Section 4.B.
• Clean fixed glass assembly. See Section 4.B.
• Replace the fixed glass assembly.
Note: Some installations may require additional run time
to cure. If odors persist after the initial break-in period,
run the fireplace for an additional three to four hours
continuously on high.
Note: Some IPI systems have a safety feature that
automatically shuts down the fireplace after 9 hours of
continuous operation without receiving a command from
the remote control. If this occurs, restart the appliance.
12 Heat & Glo • SL-5/5LP-IFT, SL-7/7LP-IFT, SL-9/9LP-IFT Owner's Manual • 2632-981 Rev. D • 1/21
I. Heat Management
Heat Output
• Change hi/lo setting on valve
• Change fan speed
If an optional fan is installed, the fan speed is controlled
by adjusting the speed control knob.
clockwise to increase the fan speed and counterclockwise
to decrease the fan speed.
Burn Rate
These models have a variable burn rate which is con-
trolled by the remote control. Therefore the flame height
is adjustable.
The flame height may be adjusted as desired by locating
the flame option on the remote control and adjusting up or
down to desired flame height.
Optional Heat Management Systems
An optional heat management system, which allows the
heat from the appliance to be redirected as desired, may
be installed with this appliance. It may be either a Heat-
Zone -Gas, which diverts heat into an adjacent room,
®
and/or a HEAT-OUT-GAS which will divert heat outside
the home/building.
Refer to Section 6 of the appliance installation manual to
confirm which of the heat management systems may be
installed together. All heat management systems must
be installed by a qualified service technician at the time of
appliance installation.
Optional Heat-Zone -Gas Kit
®
The HEAT-ZONE -GAS heat management option is
®
available for use with this appliance and must be used in
conjunction with the IFT-RC400 control. The Heat-Zone
Kit draws heat from your fireplace to an adjacent room in
your home, up to 20 feet away.
Optional Heat-Out-Gas Kit
The HEAT-OUT-GAS heat management option is
available for use with this appliance and is operated with
a wall switch. The Heat-Out-Gas kit draws heat from your
fireplace and directs it outside, up to 25 feet away.
Turn the knob