Advertisement
F. SUSPENSION & DRIVELINE INSTALLATION
CHASSIS BAG
4x12mm BCS (4)
24 • STAMPEDE 4X4
F6. Install rear assembly to chassis
Install slipper clutch assembly into chassis
Install rear module onto chassis
Tip: Wiggle rear driveshafts
until the slipper clutch
assembly shaft seats into
the rear differential input.
Note: Make sure the
rear bulkhead is mated
to the chassis properly
as shown before
tightening screws.
4x12mm
BCS
Note: Slipper clutch drive hub
seats into center driveshaft
4x12mm
BCS
Advertisement
