Traxxas 9690 Installation Instructions

LED Light Bar Kit Installation Instructions
Kit contents:
• High-Voltage Power Amplifier
• Front body bumper with LED light bar
• Body bumper mount
• Roof skid plate with front
and rear LED light bars
• Breakaway cable adapter
• Body templates
• Adhesive foam block
• 3x10mm cap screws (4)
1
9510
2584
3x12mm CS
Remove the left and right roof skid pads (A) (discard or save for future
use), the left and right rear body reinforcements, and the body cage
from the vehicle body. Retain and reuse all hardware. Refer to the
Body Exploded View to aid in the disassembly/assembly process.
2 B
Peel the adhesive backing from Template 2. Place the template on the
front of the body as shown, using the body lines for alignment (2B). Using a
tapered body reamer, carefully cut holes in the body to the dotted lines on
the template.
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
• 3x15mm cap screws (2)
• Zip ties (6)
Tools needed (all not included
and sold separately):
• 2.5mm hex wrench
• Needle nose pliers
• Tapered body reamer (part #3433 or #3433X)
• Body scissors (part #3431 or #3432)
• Isopropyl alcohol (for cleaning/degreasing)
A
9510
2584
3x12mm CS
Template 2
TR A XXA S .c om
CAUTION: RISK OF INJURY!
Use care with hobby knives, tapered reamers, and
other cutting tools as they are extremely sharp and can
cause severe injury, deep cuts, and/or punctures.
CAUTION: RISK OF DAMAGE
TO ELECTRONICS!
damage to the electronic speed control (ESC) and/or the
high-voltage power amplifier, ensure the battery is
disconnected before plugging the amplifier into the ESC.
2 A
Align with existing screw
Body Modification:
Before installation of the new roof skid plate
and front body bumper, the vehicle body will
need modification.
Peel the adhesive backing from Template 1.
Place the template on the roof of the body,
aligning the small template holes with the
corresponding screw holes in the roof (2A).
Using a tapered body reamer, carefully cut
holes in the roof to the dotted lines on the template (note the hole
diameters indicated on the template and the corresponding diameter
measurements on the body reamer). Use body scissors to cut out the
section between the four holes, along the dotted lines as indicated.
2 C
Peel the adhesive backing from Template 3. Place the template on the
body (2C), aligning the bottom of the template with the holes in the
body cut using Template 2 from the previous step. Using a tapered body
reamer, carefully cut holes in the body to the dotted lines on the template.
Use body scissors to cut out the section between the six holes, along the
dotted lines as indicated
Visitez Traxxas.com/manuals pour télécharger
les instructions dans votre langue.
Visite la página Traxxas.com/manuals para
descargar el instrucciones en su idioma.
Auf Traxxas.com/manuals, können Sie
anleitung in Ihrer Sprache downloaden.
Covers Parts #9690, 9691, 9692, 9693
To prevent
Template 1
holes in the roof
Tapered Body Reamer
Diameter Measurements
Template 3
HKC22036-R03 Rev 221215