Advertisement
F. SUSPENSION & DRIVELINE INSTALLATION
CENTER DRIVELINE BAG
Slipper Clutch Spring
54T Spur Gear
Slipper Hub
Slipper Input Shaft
Slipper Pressure Plate
Slipper Steel Disc
Drive Hub
2x9.8mm Pin
M5x0.8 NL
10x15x4mm BB
Slipper Hub Adapter
5x11x4mm BB
Slipper Friction Material (3)
3x6mm CS (3)
4x3mm GS
CHASSIS BAG
Steering Servo Horn
3x6mm BCS
22 • STAMPEDE 4X4
F1. Build slipper clutch assembly
1
Slipper friction material install
10x15x4mm
BB
Slipper Hub
M5x0.8
Adapter
NL
Slipper Clutch Spring
2
Tighten the slipper clutch adjusting nut clockwise until the slipper
clutch adjusting spring fully collapses (do not overtighten), and
then turn the slipper clutch nut counterclockwise one full turn.
F2. Center the steering servo
1
Turn transmitter on
(see Quick Start)
3
Turn on the model
(see Quick Start)
5
Unplug battery and turn transmitter off
3
7
Slipper Friction
Material
5x11x4mm
BB
54T Spur Gear
F3. Install servo horn on steering servo
2
Plug battery into ESC
(see Quick Start)
4
Set Steering Trim to Zero
(see Quick Start)
Pressure Plate
Slipper
Steel Disc
Slipper Hub
3x6mm
CS
3
4x3mm GS
Drive Hub
3x6mm
BCS
Note orientation - Servo horn will face straight ahead
2x9.8
Pin
7
Slipper Input
Shaft
Slipper
Note: Align grub screw
with flat spot on shaft
Steering
Servo Horn
Advertisement
