Example In Using A Linear Axis As The Base Axis - Mitsubishi Electric MELDAS C6 Parameter Manual

9.3 Example in Using a Linear Axis as the Base Axis

9.3 Example in Using a Linear Axis as the Base Axis
(1) When "mdvno" or "pdvno" exists at both ends of "rdvno":
Division point number
Specified machine position
Real machine position
Compensation Incremental
amount Absolute
If the setting range (mdvno to "pdvno") is exceeded‚ the compensation will be based on compensation
amount at mdvno or "pdvno".
(2) When the range compensated is only the positive range:
Division point number
Compensation Incremental
amount Absolute
If the machine position exceeds "pdvno"‚ the compensation will be based on the compensation
amount at "pdvno". If the machine position is negative in this case‚ no compensation will be executed.
9. Machine Error Compensation
#4101 #4102 #4103
−300.000 −200.000 −100.000
−299.999 −200.000 −100.003
−6
2 6
−2
0 6
#4113 #4114 #4115
−4
2 0
−4 −2 −2
275
Get other manuals https://www.bkmanuals.com
#4104 #4105 #4106
100.000 200.000 300.000
100.002 200.002 299.999
−4
0 6
−4 −4
2
#4116 #4117
6 2
4 6
rdvno 4103
mdvno 4101
pdvno 4106
sc 1
spcdv 100000
rdvno 4112
mdvno 4113
pdvno 4117