User Switch Set Item - JVC GY-HM190AG Instructions Manual

User Switch Set Item

USER1 to USER9, LCD KEY▲/LCD
KEY▶/LCD KEY▼/LCD KEY◀
By assigning one of the following functions to each
of the [F.ASSIST/1], [TC/2], [LOLUX/3],
[C.REVIEW/4], [ZEBRA/5], [OIS/6], [REC/7],
[EXPANDED FOCUS/8], [AWB/9] buttons or the
cross-shaped buttons on the LCD monitor, these
buttons can be used to control the assigned
function (on/off, start, switch).
Set according to the shooting conditions. Usable
only in the Camera mode.
[Setting Values: None, Zebra, Marker, Bars, Focus
Assist, OIS, LCD Backlight, Lolux, AE/FAW Lock,
Face Detect, OK Mark, Clip Cutter Trig, Backup
Trig, Clip Review, Load Picture File, White
Balance, TC Preset, AWB, Rec, Preset Zoom1,
Preset Zoom2, Preset Zoom3, Push AF/AF Lock,
One Push Iris, Expanded Focus]
Memo :
"Rec" can only be assigned to the [REC/7],
0
[EXPANDED FOCUS/8] and [AWB/9] buttons.
Lolux
To increase the sensitivity when in dim
surroundings, set a value in the Lolux mode.
[Setting Values: 36dB, R30dB]
Clip Review
For specifying the operation when any of the
[USER1]-[USER9], [LCD KEY▲], [LCD KEY▶],
[LCD KEY▼], or [LCD KEY◀] items is set to "Clip
Review".
Last 5sec:
0
Views about 5 seconds of the clip from the
ending.
Top 5sec:
0
Views about 5 seconds of the clip from the
beginning.
Clip:
0
Views the entire clip.
[Setting Values: RLast 5sec, Top 5sec, Clip]
92
Camera Function Menu
Face Detect
For specifying the operation when any of the
[USER1]-[USER9], [LCD KEY▲], [LCD KEY▶],
[LCD KEY▼], or [LCD KEY◀] items is set to "Face
Detect".
Select the control to track results of face detection.
AF&AE:
0
Sets auto focus and exposure control for the
face that is being tracked.
AF:
0
Sets auto focus for the face that is being tracked.
[Setting Values: RAF&AE, AF]
(A P47 [Adjusting the Focusing by Face
Detection] )
Memo :
Face detection does not function when the "MF"
0
mode is enabled using the [AF/MF] selection
button.
When "AF" is specified, this function will be
0
activated only when the "AF" mode is enabled
using the [AF/MF] selection button.
When "AF&AE" is specified, this function will
0
operate when the "AF" mode is enabled using
the [AF/MF] selection button, and when one or
more of the items (Gain, Iris and Shutter) is set
to Auto mode.
9 Sensitivity
For setting the level of ease of face detection.
[Setting Values: RHigh, Middle, Low]
9 Hysteresis
For setting the margin to maintain status when the
face that is being tracked is lost.
Set to "Fast" to select another object immediately
if the face on the screen is lost.
Set to "Slow" to operate at the same position for
some time even if the face on the screen is lost.
[Setting Values: Fast, RMiddle, Slow]