Table of Contents
Advertisement
Memo :
When [Main Menu] B [A/V Set] B [Audio Set] B
0
[Limiter] is set to "Off" while in the automatic
adjustment mode, the limiter operates at
-6 dBFS.
When [A/V Set] B [Audio Set] B [Audio On FULL
0
AUTO] is set to "SW Set", you can switch the
audio recording mode with the [AUDIO SELECT
CH-1/CH-2 AUTO/MANU] switch on the camera
recorder even if the [FULL AUTO] button is set
to "ON".
(A P106 [ Audio On FULL AUTO ] )
Setting the Audio recording Level in the
Main Menu
* Enabled only when the handle unit is not
attached.
1 Select [Main Menu] B [A/V Set] B [Audio
Set] B [Audio Level].
The [Audio Level] screen appears.
0
Audio Level
Manual
Auto
.
* The contents displayed on the screen vary
depending on the various settings.
2 Select "Auto" or "Manual" using the
[LOLUX/3] button.
If "Auto" is selected, the audio recording level
0
will be automatically adjusted.
If "Manual" is selected, the volume appears
0
on the screen. Use the cross-shaped button
(H I) to adjust the volume.
Memo :
When the [FULL AUTO] button is set to "On" and
0
[Audio On FULL AUTO] in the menu is set to
"Auto", the audio recording level cannot be
selected.
If both CH1 and CH2 are set to the built-in
0
microphone or to AUX, settings for CH2 will not
be displayed, and the settings for CH1 will apply
to CH2.
Monitoring Audio Sound
During Recording Using a
Headphone
You can check the recorded audio using
headphone.
.
1 Connect the headphone.
2 Select [Main Menu] B [A/V Set] B [Audio
Set] B [Monitor].
3 Adjust the monitor volume using the J / K
volume buttons on the side of the camera
recorder.
Memo :
Set
There is no audio output from the monitor
0
speaker in Camera mode.
Warning tone is output when there is an
0
abnormality in the camera recorder or when the
battery is low.
(A P133 [Warning Tone] )
You can set the volume of the warning tone in
0
[Main Menu] B [A/V Set] B [Audio Set] B [Alarm
Level]. (High/Low/Off)
(A P106 [ Alarm Level ] )
61
Audio Recording
Advertisement
Table of Contents
