Ink System Unit - Epson Stylus OFFICE B30 Service Manual

EPSON Stylus C110/C120/D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70
When installing the ASF Unit, be sure to align the guide pins
(x2) of the Base Frame with the positioning holes (x2) of the
ASF Unit shown in the
When routing the PE Sensor cable, pay attention to the
following instructions.
• Route the cable in the order given in
• Make sure to face the blue line of the cable toward the Base
Frame.
Figure 4-72. Routing PE Sensor Cable
• Check if there is no slack in the cable.
After removing/replacing the ASF Unit, be sure to perform the
A D J U S T M E N T
R E Q U I R E D
specified adjustment. See
After replacing the ASF Unit, be sure to perform the required
lubrication. See Chapter 6 " MAINTENANCE" (p.107)
DISASSEMBLY/ASSEMBLY
Figure 4-70.
Figure 4-68.
PE Sensor Cable
Chapter 5 " ADJUSTMENT" (p.98)
Disassembling Printer Mechanism

4.5.16 Ink System Unit

Part/Unit that should be removed before removing Ink System Unit
Upper Housing/Lower Housing/Main Board Unit/Left Frame/Panel Unit/Front
Frame/Right Frame/CR Motor/CR Scale/Hopper/Main Frame Assy./ASF Unit
Removal Procedure
When disassembling/assembling the Ink System Unit, pay attention
C A U T I O N
to the following instructions.
Be cautious not to get injured with the sharp metal edges of the
Frame Support.
Figure 4-73. Sharp Edges of Frame Support
Do not touch or damage the Sealing Rubber or the Head
Cleaner.
Mark the connection location before removing the Ink Tube.
Revision C
Frame Support
Confidential
92