Table of Contents
Advertisement
TECHNICAL SPECIFICATION
Voltage:
220-240 V~ 50/60 Hz max. 10A
Absorbed power:
Pressure:
Water tank capacity:
Size: LxHxD:
Cable length:
Weight:
Beans container capacity:
DISPLAYED MESSAGES
DISPLAYED MESSAGE
FILL TANK
GROUND TOO FINE ADJUST
MILL
alternating with...
INSERT WATER SPOUT AND
PRESS OK
INSERT WATER SPOUT
EMPTY GROUNDS CONTAINER The grounds container is too full or more than
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
ADD PRE-GROUND COFFEE
1350W
1,5 MPa (15 bar)
1,8 L
280x375x360mm
1500 mm
10,5 Kg
200 g
POSSIBLE CAUSE
Insufficient water in the tank.
The grinding is too fine and the coffee is deli-
vered too slowly or not at all.
The water spout is not inserted or is inserted
incorrectly.
3 days have passed since you last made coffee
(this guarantees correct hygiene of the machi-
ne).
been replaced.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel.
The appliance complies with the following EC
directives:
•
Low Voltage Directive 2006/95/EC and subsequent
amendments;
•
EMC Directive 2004/108/EC and subsequent amendments;
•
European Standby Regulation 1275/2008
•
Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
DISPOSAL
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
SOLUTION
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
Repeat coffee delivery and turn the grinding
adjustment knob one click clockwise towards
"7" while the coffee mill is in operation. If after
making at least 2 coffees delivery is still too
slow, repeat the correction procedure, turning
the grinding adjustment knob another click
until delivery is correct. If the problem persists,
press the OK button to deliver water from the
spout until it flows out normally.
Insert water spout as far as it will go.
Empty the grounds container and clean, then
replace. Important: when removing the drip
tray, the grounds container must be emptied,
even if it contains few grounds. If this is not
done, when you make the next coffees, the
grounds container may fill up more than ex-
pected and clog the machine.
Open the service door, remove the drip tray
and insert the grounds container.
Place pre-ground coffee in the funnel or
deselect the "pre-ground" function.
17
Advertisement
Table of Contents
Troubleshooting
