Table of Contents
Advertisement
LONG
Please note:
To make two cups of coffee, press the button twice rapidly.
Programming quantity
To modify the quantity of coffee delivered, proceed as follows:
1. Place a cup under the coffee spouts ( fig. 9).
2. Keep the button corresponding to the quantity to be
modified pressed until the message "PROGRAM QUANTITY"
is displayed and coffee delivery begins. Then release the
button.
3. As soon as the coffee in the cup reaches the required level,
press the same button again.
The quantity set has now been programmed.
Regulating the coffee mill
The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
However, if after making the first few coffees you find that
delivery is either too fast or too slow (a drop at a time), this can
be corrected by adjusting the grinding adjustment knob (fig.
10).
Please note!
The grinding adjustment knob must only be turned when the
coffee mill is in operation.
For faster delivery (not a drop at a time),
turn one click clockwise towards "7"
(coarser ground coffee).
For fuller bodied creamier coffee, turn
one click anticlockwise towards "1" (finer
ground coffee).
These adjustments will only be evident after at least 2 cups of
coffee have been delivered.
If delivery is still too fast or too slow, repeat the correction, turn-
ing the knob another click.
Manual rinsing
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath. Avoid contact with
splashes of water.
For hotter coffee, before making the coffee rinse the appliance
by pressing the
the spout, heating the internal circuit and making the coffee
delivered hotter.
120 (programmable from
20 to 180)
button. Hot water flows out of
Tips for a hotter coffee
For a hotter coffee, you are recommended to:
•
before delivering coffee, perform a rinse cycle, see previous
section "Manual rinse".
•
place the cups on the cup warmer until they are warm;
•
warm the cups by rinsing them with hot water (using the
hot water function);
•
set a higher coffee temperature in the menu.
Preparing coffee using coffee beans
Important!
Do not use caramelised or candied coffee beans as they could
stick to the coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 11).
2. Place under the coffee spouts:
- 1 cup, if you want 1 coffee (fig. 9);
- 2 cups, if you want 2 coffees (fig. 12);
3. Lower the spouts as near as possible to the cup. This makes
a creamier coffee (fig. 13).
4. Press the button corresponding to the coffee required once
or twice (fig. 8).
5. Once the coffee has been made, the appliance prepares for
use again.
Please note:
•
While the machine is making coffee, delivery can be
interrupted at any moment by pressing one of the coffee
buttons.
•
At the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) one of the coffee
buttons.
Once the coffee has been made, the appliance is ready to use
again.
Important!
If the coffee is delivered a drop at a time, too fast and not creamy
enough or too cold, read the tips in the "Troubleshooting"
section on page 17.
Various alarm messages could be displayed while the machine
is in use. Their meaning is explained in the section "Displayed
messages" (page 16).
Making coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
•
Never use more than one level measure or it
could dirty the inside of the machine or
12
Advertisement
Table of Contents
Troubleshooting
