4.10 Burner refitting
Refit the burner to the slide bars 3)(Fig. 22) at approximately
4" from the sleeve 4) - burner positioned as shown in (Fig. 12,
page 18) - insert the ignition electrode cables.
Remove the extension bars 31)(Fig. 6, page 11).
Slide the burner up to the sleeve so that it is positioned as
shown in (Fig. 22);
refit screws 2)(Fig. 22) on slide bars 3) including the safety
plate 15) Fig. 12, page 18;
secure the burner to the sleeve by tightening screws 1);
connect the oil pipes again by screwing on the two connectors
6)(Fig. 12, page 18).
20095074
Installation
2
3
1
22
GB
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
WARNING
4
5
20097600
6
14
Fig. 22