Fujitsu F2MC-16L Hardware Manual page 43

I Connecting a probe (using flat cables)
CAUTION
Prohibition
Connect flat cables to probe connectors B1 and B2 on the adapter board, as shown in Figure
2.4-2 "Connecting a probe (using flat cables)".
Adapter board
PROBE CN A1
PROBE CN B1
To connect a flat cable, push its connector into probe connector B1 or B2 until the eject locks
on both sides of the flat cable connector lock.
To disconnect a flat cable, pinch the eject locks on both sides of the flat cable connector until
the flat cable unlocks, and pull out the connector.
Make sure that power to the product is turned off and the power plug is
disconnected from outlets before connecting or disconnecting cables.
Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable.
Always grasp the power plug or connector itself. Pulling the cable may
expose conductors or sever wires in it, possibly resulting in device
problems, fire, or electric shock.
Figure 2.4-2 Connecting a probe (using flat cables)
PROBE CN A2
PROBE CN B2
Flat cables
Eject locks
Get other manuals https://www.bkmanuals.com
2.4 Connecting a Probe
29