Adjusting Hand And Day Indicator Alignment; Phone Finder; Configuring Watch Settings; Changing The Home City Summer Time Setting - Casio Edifice EQB-1200D-2AER Operation Manual

Adjusting Hand and Day
Indicator Alignment
If the hands and/or day indicator are out of
alignment even though auto time adjustment
is being performed, use EDIFICE Connected
to adjust them.
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Perform the operation shown on the
phone screen to correct hand and day
indicator alignment.

Phone Finder

You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
Do not use this function in areas where
●
phone call tones are restricted.
The tone sounds at a high volume. Do
●
not use this function when listening to
phone output over earphones.
1. X
If the watch is connected with a phone,
press any button to terminate the
connection.
This will cause the watch to enter the
Calendar Mode.
Connected Disconnected
Watch Operation Guide 5666
2. X
Hold down (B) for at least four seconds
until the second hand points to
A connection will be established between
the watch and phone, and then the
phone's ringtone will sound.
It will take a few seconds before the
●
phone tone sounds.
3. X
Press any button to stop the tone.
You can press any watch button to stop
●
the phone tone, but only during the first
30 seconds after it starts to sound.

Configuring Watch Settings

You can use EDIFICE Connected to specify
the amount of time until the Bluetooth
connection is automatically terminated, and to
configure other settings.
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Select the setting you want to change
and then perform the operation shown on
the phone screen.
Changing the Home City
Summer Time Setting
.
e
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Perform the operation shown on the
phone screen to change your Home City
summer time setting.
Checking the Watch Charge
Level
Use the procedure below to check the current
charge level with EDIFICE Connected.
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Use EDIFICE Connected to check the
charge level.
13