Recording Waypoints And Their Altitudes (Mission Log); Configuring World Time Settings - Casio 5713 Operation Manual

Recording Waypoints and
Their Altitudes (Mission Log)
Route Log uses CASIO WATCHES GPS to
record the waypoints of your routes. At the
same time, the watch takes altitude readings
every two minutes and stores them in memory,
and automatically transfers altitude data to
CASIO WATCHES every hour.
1. Y
Tap the "CASIO WATCHES" icon.
2. X
Enter the Altimeter Mode.
Navigating Between Modes
l
3. X
Hold down (A) for at least five seconds.
Release the button after [LOG] starts to
flash, and the second hand moves to
When a connection between the watch
and phone is established, [LOG] will
change to [LOG ON].
This indicates that Mission Log is
●
enabled.
Trying to connect Connected
To disable Mission Log, hold down (A)
●
again for at least five seconds.
Note
[LOG] is displayed while Mission Log
●
is enabled.
Mission Log becomes disabled
●
automatically 12 hours after it is
enabled.
Mission Log remains enabled even if
●
you change to another mode.
The watch has enough memory to hold
●
up to 60 altitude records. Recording
data when there are already 60
records in memory will automatically
delete the oldest record to make room
for the new one.
Watch Operation Guide 5713
Data Transfer
●
After Mission Log is enabled, data transfer
starts when the number of altitude records in
watch memory reaches 30.
Auto data transfer is performed during the
●
normal state of each mode.
The display cycles as shown below as data is
being transferred.
.
The second hand will point to [RC].
●
If data transfer fails for some reason, the
●
watch will return to the previous screen with
[LOG] flashing.
Note
If auto transfer fails for some reason,
●
the watch will keep trying up to five
times at 10-minute intervals. Or data is
transferred when a CASIO WATCHES
connection is established.
Configuring World Time
Settings
Specifying a World Time City with the CASIO
WATCHES phone app causes the watch's
World Time City to change accordingly.
Settings can be configured to perform auto
summer time switching for the World Time
City.
Note
The CASIO WATCHES phone app
●
World Time lets you select from among
approximately 300 cities as the World
Time City.
You can use the CASIO WATCHES
●
phone app to configure settings for
user cities that are not included in the
watch's built-in World Time Cities. You
must use the CASIO WATCHES
phone app to select a user city as your
World Time City.
To select a World Time City
●
1. Y
Tap the "CASIO WATCHES" icon.
2. X
Hold down (B) for at least five seconds.
Release the button when the second hand
points to , and [CNCT] flashes on the
display.
When a connection is established
●
between the watch and phone, [CNCT]
will stop flashing.
If connection fails for some reason,
●
[ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
Trying to connect
3. Y
Perform the operation shown on the
phone screen. The World Time setting will
be reflected on the watch.
Connected
19