Using The Crown; Shifting The Hands; Charging - Casio 5713 Operation Manual

Using the Crown

The watch's crown is a screw-in (screw lock)
type. To use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
Crown
Loosen
Important!
To prevent loss of water resistance
●
and/or damage due to impact, be sure
to screw the crown in by rotating it
away from you as you push it in.
Screw in
When pushing the crown back in, take
●
care not to apply too much force.
Fast Forward/Fast Reverse
●
After pulling out the crown, rotating it quickly
in succession in either direction will start a fast
forward or fast reverse operation. While
adjusting the time setting manually using
watch operations, rotating the crown quickly in
succession again while a fast forward
operation is in progress will cause the hour
and minute hands to move faster.
Stopping Fast Forward/Fast Reverse
●
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
If operation after pulling the crown is
disabled, the display will appear as
shown below immediately after you
pull out the crown. If that happens,
push the crown back in and lock it.
Watch Operation Guide 5713

Shifting the Hands

Hand shift moves the hands out of the way for
easy viewing of display information.
1.
While holding down (E), press (B).
This will shift the analog hands to allow
easy viewing of display information.
2.
To return the hands to their normal
timekeeping positions, hold down (E) as
you press (B) again, or press (B) to
change to another mode.
Note
If you leave the watch with its hands
●
shifted and do not perform any
operation for about one hour, the
hands will resume normal timekeeping
automatically.

Charging

This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
Charging the Watch
●
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
YES NO
Important!
Some light sources and environments
●
can cause the watch to become
extremely hot during charging, which
creates the risk of burn injury and
damage to internal watch
components.
Avoid charging the watch under
conditions like the ones described
below, where the temperatures may
exceed 60 °C (140 °F).
On the dashboard of a vehicle
ー
parked in the sun
Near incandescent lamps, camera
ー
lights, halogen lamps, or other
sources of heat
In locations exposed to direct
ー
sunlight for long periods and other
hot locations
The display panel may become black
●
(or white, depending on the LCD type)
under very high temperatures. This is
temporary, and the display will return
to normal at lower temperatures.
11