Do not operate the crown or buttons while ー retailer or to an authorized CASIO service Example of Daily Use your watch is submersed in water or wet. center. Hand washing, rain Avoid wearing your watch while in the ー ...
Page 3
Electrostatic charge can cause the display ● to go blank momentarily or cause a rainbow Note that CASIO Computer Co., Ltd. effect on the display. assumes no responsibility for any damage or loss suffered by you or any third party arising through the use of your watch or its malfunction.
Watch Operation Guide 5714 General Guide Watch Face and Display Before Getting Indicators Started... ① ② ③ This section provides an overview of the watch ① ⑤ and introduces convenient ways it can be ⑥ ② used. ⑦ Watch Features World Time ●...
Watch Operation Guide 5714 Navigating Between Modes Viewing the Face in the Dark Note Each press of (C) cycles between watch The watch has an LED light that you can turn Auto Light is disabled when any one of ●...
Watch Operation Guide 5714 Specifying the Illumination Duration ● Time Adjustment Press (C). You can select either 1.5 seconds or three seconds as the illumination duration. Use (D) to change the summer time Use the procedures in this section to adjust the setting.
Watch Operation Guide 5714 Switching between 12-hour and 24- ● World Time Keep pressing (C) until the setting you hour Timekeeping want to change is flashing. You can specify either 12-hour format or 24- Each press of (C) moves the flashing to hour format for the time display.
Watch Operation Guide 5714 Specifying a World Time City Swapping Your Home Time Alarm and World Time Use the procedure in this section to select a World Time city. If you are in an area that The watch will beep when the alarm time is...
Watch Operation Guide 5714 Enabling the Hourly Time Use (B) and (D) to change the hour setting. Enter the Alarm Mode. Signal Navigating Between Modes Holding down (B) or (D) scrolls through ● settings at high speed. Use (D) to scroll through the alarm ([AL1] Enter the Alarm Mode.
Watch Operation Guide 5714 Measuring Elapsed Time Measuring a Split Time Stopwatch Enter the Stopwatch Mode. Enter the Stopwatch Mode. The stopwatch measures elapsed time in units Navigating Between Modes Navigating Between Modes of 1/1000 second up to 99 hours, 59 minutes, If a stopwatch timing operation is in 59.999 seconds (100 hours).
Watch Operation Guide 5714 Measuring Lap Times Specifying the Distance Viewing the Speed Display Before measuring speed, specify a distance. When measuring the elapsed time in Enter the Stopwatch Mode. Stopwatch Mode, the speed value is obtained The distance setting range is 0.1 to 99.9. The...
Watch Operation Guide 5714 Setting the Countdown Start Using the Timer Timer Time Enter the Timer Mode. The timer counts down from a start time The countdown start time can be set in 1- Navigating Between Modes specified by you. A beeper sounds when the minute units up to 24 hours.
Watch Operation Guide 5714 Hand Alignment Other Information City Offset St. John’s -3.5 Adjustment Rio de Janeiro This section provides non-operational Praia information you also need to know. Refer to Strong magnetism or impact can cause the The information in the above table is current this information as required.
Watch Operation Guide 5714 Specifications Troubleshooting Other : Auto-return Accuracy at normal temperature : Power Supply : ±15 seconds a month CR1220 x 1 Indicators and Current Time Timekeeping : Battery life: Approximately 2 years Analog Conditions: Hour, minute (moves every 20 seconds) I don’t know what mode the watch is...
Page 16
Watch Operation Guide 5714 Alarm and Hourly Time Signal An alarm does not sound. The alarm’s settings may not be configured. Configure the alarm settings. Configuring Alarm Settings The hourly time signal does not sound. The hourly time signal may be disabled.