Pre-Operation Engine Service; Oil; Engine Coolant System; Battery Connection - Lincoln Electric DUAL VANTAGE 700 (AU) Operator's Manual

PRE-OPERATION ENGINE SERVICE

DUAL VANTAGE ® 700 (AU)
READ the engine operating and maintenance instruc-
tions supplied with this machine.
WARNING
• Keep hands away from the engine
muffler or HOT engine parts.
• Stop engine and allow to cool before
fuelling.
• Do not smoke when fuelling.
• Fill fuel tank at a moderate rate and do not over-
fill.
• Wipe up spilled fuel and allow fumes to clear
before starting engine.
• Keep sparks and flame away from tank.
------------------------------------------------------------------------

OIL

The DUAL VANTAGE
®
engine crankcase filled with high quality SAE 10W-30
oil (API class CD or better). Check the engine oil lev-
els before starting the engine. If it is not up to the full
mark on the dip stick, add oil as required. Check the
oil level every four hours of running time during the
first 35 running hours. Refer to the engine Operator's
Manuals for specific oil recommendations and break-
in information. The oil change interval is dependent on
the quality of the oil and the operating environment.
Refer to the engine Operator's Manuals for the proper
service and maintenance intervals.
FUEL
USE DIESEL FUEL ONLY
• Fill the fuel tank with clean, fresh diesel fuel. The
capacity of the fuel tank is approximately 25 gallons
(95 liters). See engine Operator's Manual for specif-
ic fuel recommendations. Running out of fuel may
require bleeding the fuel injection pump.
NOTE: Before starting the engine, open the fuel shut-
off valve (pointer to be in line with hose).
FUEL CAP
Remove the plastic cap covering from the Fuel Tank
Filler neck and install the Fuel Cap.
700 (AU) is shipped with the
ENGINE COOLANT
HOT COOLANT can burn skin.
•Do not remove cap if radiator is hot.
------------------------------------------------------------------------
The welder is shipped with the engine and radiator
filled with a 50% mixture of ethylene glycol and water.
See the MAINTENANCE section and the engine
Operator's Manual for more information on coolant.

BATTERY CONNECTION

GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes
away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY — disconnect
negative cable from old battery first and connect
to new battery last.
• CONNECTING A BATTERY CHARGER — remove
battery from welder by disconnecting negative
cable first, then positive cable and battery clamp.
When reinstalling, connect negative cable last.
Keep well ventilated.
• USING A BOOSTER — connect positive lead to
battery first then connect negative lead to nega-
tive battery lead at engine foot.
BATTERY ACID can burn eyes and skin.
• Wear gloves and eye protection and
be careful when working near battery.
• Follow instructions printed on battery.
------------------------------------------------------------------------
IMPORTANT: To prevent ELECTRICAL DAMAGE
WHEN:
a) Installing new batteries.
b) Using a booster.
Use correct polarity — Negative Ground.
A-4
INSTALLATION
WARNING
WARNING