Diagnostic Tool Connector - KYMCO X-Town 250 ABS Service Manual

13. FUEL INJECTION SYSTEM
Apply oil onto a new O-ring.
When install the MAP onto the throttle body,
being careful not to damage the O-ring.
＊
Always replace an O-ring with a new one.
Install the set plate and tighten the screw
securely.
Apply oil onto a new O-ring.
When install the ISC and set plate onto the
throttle body, being careful not to damage
the O-ring.
DIAGNOSTIC TOOL
CONNECTOR
INSPECTION
Put the side stand up and engine stop switch
is at "RUN".
Turn the ignition switch to "ON"
Measure the voltage between the following
terminals of the diagnostic tool connector
with PDA tester.
Terminal
Black (+) – Green (-)
White/Yellow (+) – Green (-)
Screw/Set Plate
Normal
Battery voltage
Battery voltage
－1 V
MAP
O-ring
Screw ISC/Set Plate
Diagnostic Connector
X-Town250/300 ABS
MAP
13-30