Helmet Lock; Seat Lock; Tool Kit - KYMCO Quannon 150 Owner's Manual

CONTROLS & FEATURES

Helmet lock

1 1 1 1 1
To use the helmet lock:
1. Insert the ignition switch key and rotate it clockwise to open
the lock
2. Put the helmet's strap ring into the lock's pin 1 and push
the outside of the pin 2 in to secure the lock.
3. To remove the helmet, use the key to open the lock.
Do not ride your motorcycle with a helmet attached
to the helmet lock. The lock is not intended to be a
helmet holder. A helmet hanging from the lock could
interfere with the motorcycle's operation and may
cause a loss of control and an accident.
14
2 2 2 2 2
Seat Lock & tool kit
5 5 5 5 5
To open the seat (passenger section):
1. Insert the ignition switch key into the seat lock 3 and ro-
tate it clockwise to open the seat latch
2. Lift up on the back edge of the passenger seat 4 and
remove it from the motorcycle
3. To replace the seat, engage the hooks on the bottom of the
seat with the loops on the frame. Press down on the seat
until you hear the seat latch "clicks" indicating it is engaged.
NOTE: Lift gently up on the back of the seat to make sure
the seat is secured in the latch.
The tool kit 5 is located under the seat in the tray on the top
of the fender.
NOTE: The weight capacity of the tool tray is 3.3 lb (1.5 kg).
4 4 4 4 4
3 3 3 3 3