Table of Contents
Advertisement
CHANNEL CONFIGURATION Screens
1. Figure 21 is a graphic representation of the amplifier's output CHANNEL
CONFIGURATION. Inputs (Q) are from Q-SYS, outputs A–D (E–H not shown) represent
the amplifier output channels and their configuration.
2. Text indicating how many channels, and the output configuration. For possible
configurations refer to
"Possible Combinations" on page 9
the amplifier components.
3. Status of the amplifier and Q-SYS design indicating the design and amp are in sync.
ROUTABLE MIC/LINE INPUTS
This screen is not available on the DPA-Q
Figure 22 shows the Routable MIC/LINE INPUTS screen for channels 1–4, (channels 5–8 not
shown) which displays the status of the physical MIC/LINE INPUTS for the Q models.
1. Input channels are identified numerically, 1–4 (and 5–8 not shown)
2. Input Level – is the Peak Input Level (dBFS) and is the same as displayed in the Q-SYS
Mic/Line Input component.
3. Muted – when illuminated indicates that the Input is muted for the associated channel.
This is controlled by the Mute button on the Q-SYS Designer Mic/Line Input component.
Input channels cannot be muted from the amplifier interface.
4. Clip – indicators illuminate when the input to the Mic/Line Input component is too high.
Adjust the Preamp Gain on the Mic/Line Input component in Q-SYS Designer.
5. P12 – phantom power (+12V) is available for microphones (condenser) requiring power. You
can turn the phantom power on/off in the Mic/Line Input component in Q-SYS Designer.
TD-001585-01-B
All manuals and user guides at all-guides.com
or, the Q-SYS help for
model amplifiers.
n
15
CHANNEL CONFIGURATION
Q A
Q B
1
4 Channels: A B C D
2
3
Channel Configuration Locked to Design
— Figure 21 —
CHANNEL CONFIGURATION
ROUTABLE MIC/LINE INPUTS
Q E
Q F
1
INPUT LEVEL
1
dB
4 Channels: E F G H
2
2
dB
3
Channel Configuration Locked to Design
3
dB
4
dB
1
2
— Figure 22 —
Q C
Q D
Q G
Q H
MUTED
CLIP
P12
3
4
5
Advertisement
Table of Contents
