Table of Contents
Advertisement
PDV Series
Installation of Inner Door with Gasket
Step 11.
Clean any residual gasket residue or other debris
from combustion chamber surface before installing
the inner door/gasket assembly.
Step 12.
Place the left side inner door into position first.
Firmly position the radiused channel of the inner
door around the feedline. Using the ¼" hex drive
screws from step 6, secure left side inner door in
place. DO NOT OVER TIGHTEN SCREWS
Step 13.
Position pilot tube and igniter/sensor wire against
left side inner door flange gasket. DO NOT
ROUTE THROUGH RADIUSED CHANNEL WITH
FEEDLINE.
WARNING
Stripped fastener connections
may allow for seal breach of
inner door. A seal breach may
result in a fire or explosion
causing property damage,
personal injury or death. Do
not over tighten screws in
steps 12, 14 and 15.
35
35
35
Advertisement
Table of Contents
