Upper Feed Presser Foot - JUKI TL-15 Instruction Manual

Upper feed presser foot

CAUTION:
Generally, this presser foot is used for hard-to-feed or for difficult-to-feed materials such as velvet, jersey, vinyl,
cloth artificial leather, leather, etc. This smoothly feeds the material and prevents the material from slipping.
Screw in the
presser foot
Screw in the
presser foot
Increase Decrease
24
Turn OFF the power switch when replacing the presser foot.
Presser foot
Needle clamp
screw
Actuating lever
Turn to
decrease the
presser foot
pressure.
1
Turn off power and remove the presser
foot.
2
Install the upper feed presser foot.
Fit forked portion of the actuating lever to the
needle clamp, insert the installing portion into the
presser bar, and securely tighten the screw in the
presser foot.
Once presser foot is installed, rotate handwheel
by hand in sewing direction to confirm fork position
correctly then turn power on.
* Turn the presser foot pressure regulator to set
the presser foot pressure to "low".
to
(Set the pressure to "lowest" when sewing the vel-
vet material.)
Use the sewing machine at medium speed.