B Appendix - Accessories - Riello 20047690 Installation, Use And Maintenance Instructions

B Appendix - Accessories
Output power regulator kit for modulating operation
With the modulating operation, the burner continually adapts the
power to the heat request, ensuring a high level of stability for the
parameter controlled: temperature or pressure.
Two components should be ordered:
– the output power regulator to be installed on the burner;
– the probe to install on the heat generator.
Output regulator
Type
RWF50.3
Kit interface
OCI410 interface for ACS410 software
Interface between burner control and PC.
Facilitates viewing, handling and recording setting parameters on
site in connection with the ACS410 software.
The installer is responsible for the addition of any
safety device not foreseen in this manual.
WARNING
Kit display
Burner
RX 400 S/PV
RX 500 S/PV
Appendix - Accessories
Probe type
Temperature
Pressure
Code
20097362
Burner
RX 400 S/PV
RX 500 S/PV
Code
20109292
49 GB
Range (°C) (bar) Probe Code
Water NI 1000 RTD C5332020
Air NI 1000 RTD C5332021
Water QAE 2020 RTD C5332027
0 - 15 PSI C5332040
0-60 PSI C5332041
0 - 150 PSI C5332042
0 - 200 PSI C5332043
0 - 300 PSI C5332044
Code
20096826
20051011