Elation KLF060 User Manual page 7

S A F E T Y G U I D E L I N E S
DO NOT TOUCH the fixture housing during operation.
DO NOT shake fixture, and avoid brute force when installing and/or operating fixture.
DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the
power cord connectors are damaged or do not fit into the fixture securely with ease.
NEVER force a power cord connector into the fixture. If the power cord or any of its connectors
are damaged, replace it immediately with a new one of the same power rating.
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never
blocked. Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
TURN OFF the power and allow approximately 15 minutes for the fixture to cool down before
servicing.
ALWAYS disconnect fixture from power before performing any service and/or cleaning procedure.
ONLY handle power cord by the plug end. Never pull plug out by tugging the wire portion of
the cord.
During the initial operation of this fixture, a light smoke or smell may emit from the interior of
the fixture. This is a normal process and is caused by excess paint in the interior of the casing
burning off from the heat associated with the LED and will decrease gradually over time.
Consistent operational breaks will ensure fixture will function properly for many years.
ONLY use the original packaging and materials to transport the fixture for service.
7