Table of Contents
Advertisement
Operation
AUTO • DRY• COOL • HEAT• FAN Operation
The air conditioner operates with the operation mode of your choice.
From the next time on, the air conditioner will operate with the same operation mode.
■
To start operation
f
J
1 . P re ss
OD E
opera t io n mode.
• Each pressing of the button
changes the mode setting in
[ 1 : J- I J- 1 : J- I
sequence.
2. P ress� .
• " DlD " is displayed on the LCD.
• The OPERATION lamp lights
□
green.
'" ""'
Default Set Temperature Setting : As per BEE regulation, whenever Air Conditioner will be switched
ON from the remote, the default set temperature will be set as mentioned in below table:
Set temperature before remote switched OFF
Mode
Cool
If set temperature » 24
Note:
Whenever AC is switched OFF in dry mode and is switched ON from remote, air conditioner will
start in Cool mode and then DRY mode selection can be done using the MODE button.
NOTE
■
Notes on AUTO operation
• In AUTO operation, the system selects an appropriate operation mode (COOL or HEAT) based
on the indoor temperature and starts the operation.
• The system automatically reselects setting at a regular interval to bring the indoor temperature to
the user-setting level.
■
Note on COOL operation
• This air conditioner cools the room by releasing heat in the room outdoors. Therefore, cooling
performance may fall in higher outdoor temperatures.
■
Note on HEAT operation
• This air conditioner heats the room by bringing outdoor heat indoors. Therefore, heating
performance may fall in lower outdoor temperatures.
■
Note on DRY operation
• Eliminates humidity while maintaining the indoor temperature as much as possible. It automatically
controls temperature and airflow rate, so manual adjustment of these functions is unavailable.
■
Note on FAN operation
This mode is valid for fan only.
■
Recommended temperature setting
• For cooling: 26-28
an d se l e c t an
j-l�AN
I 7
If set temperature= 24'C
·c
°
• For heating 20-24
C
■
To stop operation
[t1/
3 _ P re ss
• " [t]D " disappears from the LCD.
• Then OPERATION lamp goes off.
■
To change the temperature
[ � P l .
setting
4. P ress
• Press _. to raise the temperature and
press T to lower the temperature.
COOL
HEAT
operation operation operation
°
°
18-32
C
10-30
Set temperature after remote switched ON
Default set temperature will be 24'C.
Default set temperature will remain same
as set prior to remote switched OFF.
°
C
ag ai n.
AUTO
DRY or FAN
operation
The temperature
C setting cannot
°
C 18-30
be changed.
5
Advertisement
Table of Contents
