Lenovo 7Z59 Manual page 35

User Action:
Information only; no action is required.
• FQXSPCN4003I: Remote Control session started by user [arg1] in [arg2] mode has been closed.
Remote Control session closed
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0194
User Action:
Information only; no action is required.
• FQXSPCR0001N: Sensor [SensorElementName] has transitioned to non-recoverable from a less
severe state.
This message is for the use case when an implementation has detected a Sensor transitioned to non-
recoverable from less severe.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0524
User Action:
Complete the following steps:
1. Please flash uEFI image to the latest level.
2. If the problem still exist, please remove and re-install CMOS battery for 30 seconds to clear CMOS
contents.
3. If the problem still exist, please contact local service.
• FQXSPCR2001I: Sensor [SensorElementName] has deasserted the transition to non-recoverable
from a less severe state.
This message is for the use case when an implementation has detected that the Sensor transition to non-
recoverable from less severe has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0525
User Action:
Information only; no action is required
• FQXSPDA2000I: The System [ComputerSystemElementName] has detected a POST Error
deassertion.
This message is for the use case when an implementation has detected that Post Error has deasserted.
.
Chapter 2 XClarity Controller events
31