Operating The Handset - Siemens Gigaset 4215 User Manual

Setting Up the Telephone

Operating the Handset

The display is protected by a plastic film.
Remove the protective plastic film!
Inserting the Batteries
Insert the batteries, as shown above.
G
Place cover and push gently upward until it clicks into place (the unit
G
is shipped with the battery cover off).
To open, press the grooved area on the cover and slide back.
G
k
Placing Handset into the Base Station and Charging the
Batteries
Ö
Turn the handset off by holding down the END key then place it in the
base station with the display facing upward toward you. After about
one minute, the handset's internal number will appear on the display
(for example"INT 1"). Successful registration is signaled by a confir-
mation beep (crescendo tone sequence).
4
Use only "AA" rechargeable NiCd or NiMH batteries. Do not
G
use Alkaline, Lithium or non-rechargeable batteries.
Never use non-Siemens charging units as these can damage
G
the batteries.
IMPORTANT! Before using your handset, you must register it
first.
For information on how to register additional handsets (bought
separately), see page 56.