Installation; Mains Water Connection - Miele CVA 7845 Operating And Installation Instructions

Mains water connection


Risk of injury and appliance
damage if appliance is not
connected properly.
Failing to connect the appliance
properly can result in personal injury
and/or material damage.
The appliance may only be
connected to the mains water
connection by suitably qualified
specialists.

Risk to health and risk of
damage due to contaminated water.
The quality of the incoming water
must conform to the requirements for
drinking water in the country where
the coffee machine is being used.
Connect the coffee machine to the
drinking water supply.
Connection to the water supply must
comply with the applicable
regulations in the country where the
appliance is being installed. All
appliances and systems used to
supply water to the coffee machine
must also comply with the applicable
regulations in the respective country.
Connect the coffee machine directly
to a fresh water pipe.
Avoid connecting the coffee machine
to a water inlet in which the water
might stagnate. Otherwise, the
flavour of the drinks could be
impaired.
The coffee machine meets the
requirements of IEC 61770 and
EN 61770.
The coffee machine may only be
connected to a cold water supply.
The water connection pressure needs
to be between 100 and 1000 kPa (1 and
10 bar).
A stopcock must be provided between
the stainless steel hose and the
household water inlet to ensure that the
water supply can be cut off if
necessary. Make sure the stopcock
remains easily accessible once the
coffee machine has been installed.
Fitting the stainless steel hose to the
coffee machine
Only use the stainless steel hose
supplied. The stainless steel hose
must not be shortened, extended or
replaced by a different hose.
A faulty stainless steel hose must
only be replaced by a genuine
original Miele replacement hose. The
food-grade stainless steel hose is
available to order via the Miele
webshop or directly from Miele (see
back cover for contact details).
The stainless steel hose supplied is
1.5 m long.
 Remove the cover cap from the
mains water connection at the back
of the coffee machine.
 Take the angled end of the stainless
steel hose and check whether there is
a washer. If there is no washer, fit
one.

Installation

107