Danby DPA135E1WDB Owner's Manual page 9

INSTALLATION INSTRUCTIONS
INSTALLING THE WINDOW KIT
The window kit can be used in either a hung
window or a sliding window. The images at the
right are for a hung window but the steps for a
sliding window are the same.
1. Cut the adhesive foam seals A and B to the
correct length for the window. Attach them to the
window sash and frame as shown.
2. Insert the assembled window slider kit into the
window opening and close the window on it.
3. Cut the non-adhesive foam seal C to match
the width of the window. Insert the foam seal
between the glass and the window frame to
prevent air and insects from getting into the
room.
4. Extend the exhaust hose and attach the window
slider adapter to the hole in the window slider. In
tricky installations, it may be easier to attach the
adapter to the slider before placing the kit in the
window.
Important: Do not over extend or bend the hose as
this will impede air fl ow.
IMPORTANT WARNING
Do not leave this air conditioner unattended in
a space where people or animals who cannot
react to a malfunction are located. A malfunction
such as the exhaust hose becoming dislocated,
can cause extreme overheating or death in an
enclosed, unattended space.
1
2
3
4
8
B
A
A
B