Installation Instructions; Required Tools - Danby DPA135E1WDB Owner's Manual

INSTALLATION INSTRUCTIONS

REQUIRED TOOLS

1. Medium sized Phillips screwdriver
2. Tape measure or ruler
3. Knife or scissors
4. Saw (in the event that the window
sliders need to be cut to size)
ACCESSORIES
1. Air outlet adapter
2. Exhaust hose
3. Window slider adapter
4. 8 bolts
5. Window slider A and B
6. Window slider C and D
7. Foam seal A and B (adhesive)
8. Foam seal C (non-adhesive)
9. Remote control and batteries
ASSEMBLING THE WINDOW KIT
1. Screw the air outlet adapter and the window slider
adapter onto either end of the exhaust hose.
2. Attach the air outlet adapter to the back of the unit by
placing it over the air exhaust and then pushing in the
direction of the arrow to lock into place.
3. Measure the window opening where the window kit will
be installed. Assemble as many sliders as needed to fi t
the window. If the length of the window requires all three
sliders, use two bolts to fasten the sliders at the correct
length. If the window opening is less than the minimum
length of a single slider, use the slider that has the hole
in it and cut it to the correct length. Make sure not to cut
the end that has the hole as this is needed to attach the
exhaust hose adapter.