DeLonghi PrimaDonna Elite ECAM656.75.MS Manual page 22

DISPLAYED MESSAGE
FILL BEANS CONTAINER
GROUND TOO FINE. ADJUST
MILL 1 CLICK WHILE IN
OPERATION
SELECT A MILDER TASTE
OR REDUCE PRE-GROUND
COFFEE QUANTITY
INSERT WATER SPOUT
POSSIBLE CAUSE
The coffee beans have run out.
The pre-ground coffee funnel (A4) is
clogged.
The grinding is too fine and the coffee is
delivered too slowly or not at all.
If the water softener filter (C4) is present,
an air bubble may have been released in-
side the circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (C6) is not inserted
or is inserted incorrectly
REMEDY
Fill the beans container(A3 - fig. 12).
Empty the funnel with the help of the brush (C5) as
described in section "16.8 Cleaning the pre-ground
coffee funnel".
Repeat coffee delivery and turn the grinding adjust-
ment dial (A5) (fig. 11) one click clockwise towards 7
while the coffee mill is in operation. If after making
at least 2 coffees delivery is still too slow, repeat the
correction procedure, turning the grinding adjust-
ment dial another click until delivery is correct (see
section "9.5 Adjusting the coffee mill"). If the prob-
lem persists, make sure the water tank (A16) is fully
inserted.
Insert the hot water/steam spout (C6) in the appli-
ance and deliver a little water until the flow becomes
regular.
Select a milder taste by pressing "
or reduce the quantity of pre-ground coffee (maxi-
mum 1 measure).
Insert the water spout as far as it will go.
27
AROMA" (B6)