Table of Contents
Advertisement
3. Turn the cappuccino maker outwards and place a container
with a minimum capacity of 100 ml underneath (fig. 2).
4. Place the main switch on the back of the appliance in the I
position (fig. 3).
5. The lights
,
6. Turn the steam dial anticlockwise as far as it will go (fig.
5). This is priming the water system. (It is normal for the
machine to make some noise).
7. Wait for delivery of hot water to stop automatically. The
lights
,
must close the steam tap by turning the steam dial to the 0
position.
8. Turn the steam dial to the 0 position. The appliance goes off
automatically.
To use the appliance, turn it on.
Please note :
•
When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the ap-
pliance starts to give satisfactory results.
TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main switch on
the back of the appliance is in the I position (fig. 3).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
•
To turn the appliance on, press the
The
and
heating up and performing an automatic rinse cycle. By cir-
culating the hot water, the appliance heats both the boiler
and the internal circuits.
When the
and
pliance is at temperature.
TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
,
flash.
,
flash to indicate that you
button (fig. 4).
lights flash while the appliance is
lights remain on steadily, the ap-
To turn the appliance off, press the
pliance performs a rinse cycle.
Please note:
If the appliance is not used for an extended period, place the main
switch in the 0 position (fig. 6).
Important!
To avoid damaging the appliance, never place the main switch
(fig. 6) in the 0 position while the appliance is on.
SETTING THE AUTO-OFF (STAND BY)
The appliance is set by default to go off if not used for two hours.
The time can be changed so that the appliance switches off after
15 or 30 minutes, or after 1, 2 or 3 hours.
1. With the appliance in stand-by (the main switch has to be
turned to I position) (fig. 3), Press and hold the ECO button
until the lights at the back of the control panel come on
(see fig. after step 2).
2. Select the required period of time (15 or 30 minutes or 1,
2 or 3 hours) by pressing the
time table).
15min
30min
3. Press the ECO button to confirm the selection: auto-off is
programmed.
Please note:
To disconnect the appliance completely, place the main switch
at the back of the appliance in the 0 position (fig. 6).
ENERGY SAVING
Use this function to enable or disable energy saving mode. En-
ergy saving mode reduces energy consumption in compliance
with current European regulations.
To activate or deactivate this mode, press the ECO button. After
a period of inactivity, if ECO mode is active the ECO button light
comes on.
This mode is active by default.
Please note:
A few seconds may elapse between energy saving mode and
delivery of the first coffee.
10
button (fig. 4). The ap-
button (see the light/
1h
2h
3h
.
Advertisement
Table of Contents
Troubleshooting
