Remove The Upper Case (With Keyboard And Touchpad) - Lenovo ThinkBook 15p Gen 2 i Hardware Maintenance Manual

Figure 29. Detach the antenna cable connectors and disconnect the EDP cable from the system board
Step 2. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove four screws and then remove the LCD module.
Figure 30. Remove the LCD module
Screw specifications
M2.5 x L5

Remove the upper case (with keyboard and touchpad)

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the battery pack" on page 31
"Remove the solid-state drive (SSD) module" on page 32
"Remove the Wi-Fi card" on page 33
"Remove the memory module" on page 34
"Remove the heat sink" on page 35
"Remove the fan" on page 35
Number of screws
4
.
Chapter 4 Removing a FRU or CRU
45