Remove The Dc-In Bracket - Lenovo ThinkBook 15p Gen 2 i Hardware Maintenance Manual

Figure 21. Remove the fingerprint board
Go to
https://support.lenovo.com/partslookup
part:
Fingerprint board

Remove the DC-in bracket

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove two screws and then remove the DC-in bracket.
Figure 22. Remove two screws and then remove the DC-in bracket
Screw specifications
M2 x L5
Go to
https://support.lenovo.com/partslookup
part:
40
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement
Number of screws
2
to look up the Lenovo part number of the following replacement