Replace Light Bulbs - Skoda KAMIQ 2020 Owner's Manual

46 Lighting, windscreen wipers and washers ›
Operation
Switching on
Switching off
›
Manually switch the high beam on or off.
Function restriction
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example:
The headlights/lights of oncoming vehicles are
▶
covered by crash barriers, for example.
The headlamps/lights of the oncoming or preced-
▶
ing vehicle are dirty or not functioning.
Settings
Activation/deactivation
The function is activated or deactivated in the fol-
lowing menu in the Infotainment system:
Or:
Activation/deactivation
The function is activated or deactivated as follows in
the Infotainment system in the menu
.

Replace light bulbs

What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
NOTICE
Danger of headlight damage due to the ingress of
water and dirt!
Always fit the protective cap on the headlight cor-
▶
rectly after changing a bulb.
Replace light bulbs
›
Push the lever in the
direction of the arrow.
It lights up in the instru-
ment cluster from
the isolation box.
Conditions for changing a bulb
✓ Ignition off
✓ Light switched off
Rear turn signal
›
Remove the cover with
the bracket from the
tool kit.
›
Unscrew A and
screws
remove the lamp.
›
Press the lock mecha-
nisms on the connec-
tor and remove the
connector.
›
Turn and remove the
socket with the bulb.