ZyXEL Communications VMG1312-B10B Series User Manual page 337

Click the Activate button to apply the changes. The following screen displays. Click Yes to save
6
the changes in all screens.
Figure 187 Red Hat 9.0: KDE: Network Configuration: Activate
After the network card restart process is complete, make sure the Status is Active in the Network
7
Configuration screen.
Using Configuration Files
Follow the steps below to edit the network configuration files and set your computer IP address.
Assuming that you have only one network card on the computer, locate the ifconfig-eth0
1
configuration file (where eth0 is the name of the Ethernet card). Open the configuration file with
any plain text editor.
• If you have a dynamic IP address, enter
shows an example.
Figure 188 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=dhcp
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
• If you have a static IP address, enter
by the IP address (in dotted decimal notation) and type NETMASK= followed by the subnet
mask. The following example shows an example where the static IP address is 192.168.1.10
and the subnet mask is 255.255.255.0.
Figure 189 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.1.10
NETMASK=255.255.255.0
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
VMG1312-B10B / VMG1312-B30B Series User's Guide
Appendix B Setting up Your Computer's IP Address
in the BOOTPROTO= field. The following figure
dhcp
in the BOOTPROTO= field. Type IPADDR= followed
static
337