Lower Front Access Panel; Condenser Coil Access Panel; Lubrication; Carbonator Water Pump Motor - Cornelius 326142000 Service Manual

(solid-state) post-mix dispenser two-flavor/hot-gas defrost with v3 electronics
Table of Contents

Advertisement

LOWER FRONT ACCESS PANEL

Remove two screws securing lower front panel, then pull panel down to remove from Unit.

CONDENSER COIL ACCESS PANEL

Pull out on top of condenser coil access panel, then lift panel up and out to remove.

LUBRICATION

CARBONATOR WATER PUMP MOTOR

(see Figure 12)
Carbonator water pump motor bearings must be lubricated periodically. Refer to oiling instructions on motor. DO
NOT OVER OIL.
DISPENSING VALVES CAGED O-RINGS AND BEATERS DRIVE SHAFTS SEALS
ASSEMBLIES
NOTE: Defrost freeze cylinders, shut Unit down, close product shutoff valves in lines leading from
product blender tanks to freeze cylinders, then drain product from freeze cylinders.
Lubricate dispensing valves caged o-rings (see Figure 7) and beaters drive shafts seals assemblies (see Figure
8) each time Unit is sanitized as follows:
NOTE: Item numbers in parentheses in this paragraph are in reference to Figure 3.
1. Remove HEX NUTS (item 7) and FLATWASHERS (item 6) securing FACEPLATE (item 8) to freeze
cylinder, then remove faceplate from cylinder.
2. Carefully remove large O-RING (item 5) from FACEPLATE (item 8).
3. Unscrew RELIEF VALVE (item 9) from FACEPLATE (item 8).
4. Disassemble dispensing valve (see Figure 7) as follows:
A.
Remove two screws and hold-down plates securing spring housing to dispensing valve body, then
remove housing.
B.
Remove torsion spring from dispensing valve.
C.
Remove knob, spring, sleeve, and lever from dispensing valve.
D.
Remove spring fitting from dispensing valve.
E.
Press valve, with caged O-ring, down and out of dispensing valve body.
F.
Carefully remove caged O-ring from valve.
5. Wash all parts in warm water. Remove all traces of syrup and lubricant, especially from faceplate, O-rings,
and dispensing valve. If parts are excessively coated, wipe clean with paper towel to remove syrup and
lubricant, especially from caged O-ring and dispensing valve. Use BRUSH (item 4, Table 3) to clean
faceplates relief valve passages.
6. Submerge all parts in four percent solution of approved sanitizing agent for time recommended by sanitizer
manufacturer.
326142000
28

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fcb

Table of Contents