Auto Cruising Zoom Operation - FujiFilm UA13x4.5BERD-S9 Operation Manual

(4) Auto Cruising Zoom Operation

In auto cruising zoom operation, the zoom moves to the tele end or the wide end at a constant speed.
This function is effective when a constant slow zoom speed is required across the zooming range.
Operation
a. Set the zoom servo/manual select knob to "S."
b. Press the zoom seesaw control lever and adjust the zoom speed.
c. While pressing the zoom seesaw control lever, press the quickzoom & auto cruising zoom switch.
－ The auto cruising zoom function will work.
d.
Release your hand from the zoom seesaw control lever.
－ The zoom will move to the tele end or the wide end at a constant speed that is determined when the
quickzoom & auto cruising zoom switch is pressed.
Note. By setting an appropriate switch in the area of "Function & Mode Select Switches" (see page 14), the
return switch and the VTR switch can be used also as a quickzoom & auto cruising zoom switch.
Releasing
There are three ways to release the auto cruising zoom operation mode.
1. Press the zoom seesaw control lever on the side of the direction of the zoom movement.
When the amount of displacement of the zoom seesaw control lever exceeds that determined when the
－
auto cruising zoom operation is set, the auto cruising zoom operation mode will be released.
After released, the zoom will move continuously toward the same direction as moved before releasing.
(In this way, the auto cruising zoom operation mode can be released maintaining the smooth zoom
movement.）
2. Press the zoom seesaw control lever on the reverse side of the direction of the zoom movement.
－
The auto cruising zoom operation mode will be released immediately, and the zoom will move toward
the reverse direction.
3. Press the quickzoom & auto cruising zoom switch.
－ The auto cruising zoom operation mode will be released immediately, and the zoom will stop.
- 9 -