Stamina wirk Ride 85-2221C Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
STEP 10
NOTE: The RIGHT PEDAL(52) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(52) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(43) has L stamped on the end
of the pedal shaft. The LEFT PEDAL(43) has left hand threads and is tightened by turning counterclockwise.
Thread the RIGHT PEDAL(52) to the RIGHT CRANK(51) as shown. Tighten the pedal securely. Refer
to the detail view B. The shoulder of the PEDALS(43, 52) should be in contact with the CRANKS(44, 51)
when securely tightened. Select the RIGHT PEDAL STRAP(97) which has R marked on the bottom side of
the strap. Snap the three hole end to the inside edge of the RIGHT PEDAL(52). Snap the other end to the
outside edge of the RIGHT PEDAL(52) with the R mark on the bottom of the RIGHT PEDAL STRAP(97).
Select adjustment holes which allow your foot to be easily removed from the pedals.
Repeat on the left side in order to attach the LEFT PEDAL(43) to the LEFT CRANK(44) and snap the LEFT
PEDAL STRAP(96) to the LEFT PEDAL(43).
STEP 11
Refer to the illustration and detail view C. Pry the METER(19) from the DESKTOP(21). Install two AAA
batteries into the METER(19), the batteries are not included. See page 13 for detailed battery installation
instructions. Press the METER(19) back to the DESKTOP(21). Plug the CONNECTION WIRE(117) into
the socket of the SENSOR WIRE(59) which located at the front of the UPRIGHT(3).
C.
Shoulder
B.
Shoulder
Shoulder
11