Regency LSC7236 Instructions

LEGACY STORAGE CABINET • LSC7236 • INSTRUCTIONS
Organize your parts and hardware. You will need a Phillips head and flat head screw driver and rubber mallet.
Hardware :
A: Mounting Bracket(8) • C: Hinge(8) D: Lock Lip(2) • E: Small Screw(4)
F: Cam Pins(20) • G: Medium Screws(56) • H: Shelf Pins(16) • I: Adjustable Glides(6) J: Large Screws(8)
K: Door Handles(4) • L: Keys(2)
A C
Parts :
M: Back • N: Front support • O: Middle Support• P: Bottom • Q: Left Side • R: Right Side • S: Shelves (4)
T: Top • U: Right side Door(2) • V: Left side Door(2) • W: Center wall
M
Figure 1: To open Cam, point
arrow toward Cam Pin hole.
To lock Cam, turn clockwise.
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
Any problems or questions call Regency Office Furniture at 1-866-816-9822 or email customerservice@regencyof.com
D F
E
N O P
G H J
I
Q R
W
K L
S
T
U
V