Advertisement
LEGACY STORAGE CABINET • LSC7236 • INSTRUCTIONS
STEP 6 : Screw in 6 adjustable glides(I) in
the locations shown below with 4 medium
screws(G) each.
I
I
P
STEP 8a : Screw 8 cam pins(F) into top(T). Use 2 small screws(E) each to attach locking lips(D).
STEP 8b : Attach top by inserting and locking cams (
F
F
D
F
STEP 9 : Attach 8 mounting brackets(A) to the pre drilled holes in the sides(Q,R) and center wall(W) with
the open end facing out. Mount the inner hinges to(W) and outer hinges to(Q,R) by sliding the bolt on the
underside of the hinges into the open end of the mount while sliding the screw on the mount into the open
end of the hinge. Tighten the screw on the back to lock into place.
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
Any problems or questions call Regency Office Furniture at 1-866-816-9822 or email customerservice@regencyof.com
I
I
V
F
I
I
F
F
T
D
F
E E
E E
D
D
A/C
STEP 7 : Place 2 cam pins(F) in bottom(P)
and attach center wall(W) with banded edge
facing out by inserting and locking cams (
Fig1).
F
F
A/C A/C
A/C
A/C A/C
W
F
F
P
A/C
A/C
Fig1).
Advertisement
