Table of Contents
Advertisement
TG6500C_Usefulinfo.fm Page 92 Thursday, September 30, 2004 4:58 PM
Cancelling Registration/Re-registration
If you have cancelled handset registration at a previous base unit (p. 91), start
from step 5.
1
Handset: Press [MENU].
2
Handset: Scroll to "Initial setting" by
pressing [d] or [B], then press the soft key
(
).
SELECT
3
Handset: Scroll to "Registration" by
pressing [d] or [B], then press the soft key
(
).
SELECT
4
Handset: Press the soft key (
registration".
5
Base unit:
Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing,
the rest of the procedure must be completed within 1 minute.
6
Handset:
(1) Press the soft key (
(2) Wait until a long beep sounds and the
display shows the new extension number
(e.g. extension number 2).
• Registration is complete.
• You can stop registration by pressing [OFF] on the handset and pressing
[LOCATOR/INTERCOM/TRANSFER] on the base unit.
• If "Wrong handset Refer to manual" is displayed, the handset you tried to
register is for KX-TG5200C/KX-TG5202C/KX-TG5230C/KX-TG5240C/
KX-FPG391C base unit, not the KX-TG6500C base unit included with this system.
The accessory handset for this base unit is KX-TGA650C.
If you have not cancelled the handset's registration at the previous base unit
(p. 91), the handset number remains in that base unit's memory. To erase the
handset number from the previous base unit, perform the following steps:
(1) Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds, and (2)
Press and hold the handset number [1]
seconds. A long beep sounds, then the handset number is erased from the base
unit memory.
92
) at "HS
SELECT
).
O K
( ) to
( )
[4]
Initial setting
Registration
HS registration
Press LOCATOR
on base unit
for 3 sec.
Then press OK
FRANÇ.
O K
SPIPRIVACY1
[2]
IN USE
Handset [2]
Registered
that you do not want for 5
Advertisement
Table of Contents
