Removal And Replacement Procedures - Scotsman HD356 User Manual

HD356

Removal and Replacement Procedures

Rotor
1. Disconnect electrical power.
Channel
2. At the back, remove two bolts securing ice
machine to dispenser. If a bin thermostat is being
used, pull the thermostat capillary tube up and out
of the hopper.
3. Push the ice machine back 5 ½ " from its
original position.
4. Locate nut holding rotor to shaft and remove it.
5. Remove the stainless steel drive channel and
block.
6. Push the rotor back and off the drive shaft.
7. Pull the rotor out of the machine.
Shaft
1. Remove washer from shaft.
2. Locate snap ring under washer and remove it.
3. Remove gear drive assembly from the front of
the dispenser.
4. Pull the shaft out of the drive housing.
Reverse to reassemble, be sure washer is in place
on shaft.
Cam Switches
All units use Cam Switch #1 (to the right of the
cam). Coin units also use Cam Switch #2 (to the
left of the cam). They must be set correctly for
proper operation.
Either switch has contacts COM to NO closed
when the unit is at stand by.
Washer
Cam SW # 2
Cam SW # 1
February 1999
Page 13