Advertisement
You can use SP332-ASST3-PL with iPads, iPhones and enjoy handsfree calling. In order to get the best results when using the device, please read this manual first before using.
DO NOT submerge the SP332-ASST3-PL speaker in water, this unit is not intended to function properly after being under water.
SP332-ASST3-PL is rated IPX6, which means the speaker can be heavily splashed with water or left in the rain(but not submerged in water) for approximately a limited time. If the SP332-ASST3-PL gets wet, it is recommended that you dry the speaker completely before using it again.
Please note: Speaker is not water-resistant when the silicone cover is open. Please make sure that cover is closed and secure before using in a wet environment.
Bluetooth Version: 2.1+EDR
Supported Profiles: A2DP, HFP, AVRCP
Bluetooth Range: 33ft (10m)
Dimensions: 180 mm x 65 mm
Battery: rechargeable Lithium-ion battery
Charging: 5V @ 500 mA
Press and Hold "ON/OFF" button 2 seconds to power ON, the Blue LED will start to flash.
If an Aux (3.5 mm) cable is connected to the unit, the Blue LED will turn off, and the Green LED will stay illuminated, notifying you, the unit is in Aux-In mode.
Press and Hold "ON/OFF" button 2 seconds to power OFF
The unit will automatically go into "Pairing Mode" when it is powered ON.
Go into your Bluetooth device settings menu and look for "Sylvania SP332"
After the unit has paired and connected, it will re-connect automatically when the unit is powered on and the device is in range.
Note: Bluetooth Timeout: 10 minutes
Press "" to start playing music
Press and Hold "" 2 seconds to play the next track
Press and Hold "" 2 seconds to play previous track
Press either "" or "" for volume control
When the unit is connected and paired to your device, the unit allows you to make or receive phone calls with its built-in microphone.
Press "" to accept a call
To end a call press ""
To reject a call, press and hold "" for 2 seconds
Plug in the supplied 3.5 mm cable into the unit. The other end is connected to your device. The Green LED will only illuminate when in "Aux" mode.
Please note music and volume can be controlled by your device.
Attach the USB cable to the unit, and plug into any USB charger. If the unit is completely discharged, it will take approximately 4 hours to fully charge.
The Red LED will illuminate during charging, when it has completed, the Red LED will turn off.
Note: There will be a beep when the battery is low and needs to be recharged.
Blue LED flashing & Blue LED solid | Bluetooth Mode |
Green LED on solid | Aux Mode |
Red LED | Charging |
Unit doesn't connect to device | Speaker needs to be connected/re-paired to device |
A tone is heard every few seconds | Speaker needs to be charged |
Unit will not power on | Speaker needs to be charged |
Unit doesn't control track(s)/volume | Speaker needs to be in Bluetooth mode for full control |
Unit distorts at high volume | The devices' volume needs to be lowered |
For service assistance and product information, please call: 1-800-968-9853.
Curtis International Ltd.
7045 BECKETT DRIVE, UNIT 15, MISSISSAUGA, ON, L5S 2A3
www.curtisint.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Sylvania SP332-ASST3-PL, 058465807528 - Speaker Quick Start Guide
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the SP332-ASST3-PL that isn't answered in the manual? Leave your question here.