Table of Contents
Advertisement
The installation procedure for both models is the same. The only difference is the position of log
eight and the addition of logs 9 and 10—the Evolve 1253 has an extra two logs.
1. Back left log
Align bottom locating holes with the locating pins at the
back of the burner—the log will sit up against the back
of the combustion chamber.
1
3. Front left small log
Refer fully assembled image for reference. Place onto
the middle left locating pin and left front locator bracket.
3
5. Front middle small log
Refer fully assembled image for reference. Place onto
the middle locating pin and central front locator bracket.
7. Front large middle log
Place onto the locating pin of log four and slot onto the
right front locating bracket.
5
7
2. Back right log
Align bottom locating holes with the locating pins at the
back of the burner—the log will sit up against the back
of the combustion chamber, and there will be a gap
between the back two logs.
4. Front right small log
Refer fully assembled image for reference. Place onto
the middle right locating pin and right front locator
bracket.
6. Front large left log
Place onto the locating pin of the first log and slot onto
the left front locating bracket.
6
8. Top upper right large log
Place onto the locating pin of log seven and swivel
OVER log 4. The end rests into the burner slot.
Evolve 952/1253 Installation Guide: 13115-F 06-22 | 19
2
4
8
Advertisement
Table of Contents
