Replacing The Air Filter Element - Yamaha TMax XP500 2012 Owner's Manual

59C-9-E1.book 15 ページ ２０１２年６月２６日 火曜日 午前１１時３３分
er by removing the screw.
1
1. Coolant reservoir cover
2. Screw
5. Open the coolant reservoir cap,
add coolant to the maximum level
mark, and then close the reservoir
cap. WARNING! Remove only
the coolant reservoir cap. Never
attempt to remove the radiator
cap when the
hot. NOTICE: If coolant is
[EWA15161]
not available, use distilled water
or soft tap water instead. Do not
use hard water or salt water
since it is harmful to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
All manuals and user guides at all-guides.com
PERIODIC MAINTENANCE AND ADJUSTMENT
wise the cooling system will not
be protected against frost and
corrosion. If water has been
2
added to the coolant, have a
Yamaha dealer check the anti-
freeze content of the coolant as
soon as possible, otherwise the
effectiveness of the coolant will
be reduced.
1. Coolant reservoir cap
engine is
Coolant reservoir capacity (up to the
maximum level mark):
0.27 L (0.29 US qt, 0.24 Imp.qt)
6. Install the coolant reservoir cover
by installing the screw.
7. Place the left floorboard mat in the
original position and push it down-
ward to secure it.

Replacing the air filter element

The air filter element should be re-
placed at the intervals specified in the
periodic maintenance and lubrication
chart. Replace the air filter element
more frequently if you are riding in un-
usually wet or dusty areas.
[ECA10472]
To replace the air filter element
1
6-15
1. Remove panel C. (See page 6-8.)
2. Remove the air filter case cover by
removing the screws.
1
1
1. Screw
2. Air filter case cover
3. Pull the air filter element out.
EAU52030
2