Yamaha TMax XP500 2012 Owner's Manual page 28

59C-9-E1.book 13 ページ ２０１２年６月２６日 火曜日 午前１１時３３分
INSTRUMENT AND CONTROL FUNCTIONS
Right
1
2
3
4
1. Engine stop switch "
2. Hazard switch " "
5
3. Start switch " "
6
Pass switch "PASS"
Press this switch to flash the headlight.
7
Dimmer switch "
8
Set this switch to "
beam and to " " for the low beam.
9
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
All manuals and user guides at all-guides.com
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch "
Press this switch to sound the horn.
2
Engine stop switch " / "
3
Set this switch to " " before starting
the engine. Set this switch to " " to
/ "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12360
Start switch " "
With the sidestand up, push this switch
while applying the front or rear brake to
EAU12400
/ "
crank the engine with the starter. See
" for the high
page 5-1 for starting instructions prior
to starting the engine.
EAU12460
/ "
The engine trouble warning light and
ABS warning light (ABS model only) will
". When re-
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
Hazard switch " "
With the key in the "ON" or "
EAU12500
" tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
EAU12660 The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12721
gine not running, otherwise the bat-
tery may discharge.
EAU44710
3-13
EAU12733
" posi-
ECA10061