Hardwire Accessory 9940 - COZY DVCF402D Owner's Manual

HARDWIRE ACCESSORY 9940

Installation Instructions:
DVCF401D/ DVCF402D/ DVCF601D/ DVCF602D
WARNING: Danger of bodily injury. Turn off
electric power supply at disconnect switch, fuse box or
service panel before working on the furnace.
SUMMARY: This accessory converts Cozy Counterflow
furnaces using the electric service cord provided, to a
hardwired, permanent electrical connection.
If this furnace is equipped or has been previously installed
and operated using the service power cord, disconnect the
cord at the receptacle connector located at the base of the
furnace and remove the cord completely from the furnace.
Following the wiring diagram below, make all the
necessary wiring connections from an outside electrical
source. All electrical work must conform to your local
codes and ordinances or in their absence, with National
Electrical Code, ANSI/NFPA 70 or in Canada, Canadian
Electrical Code C22.1. If you are not familiar with wiring
codes in general, have a competent electrician do this job.
Be sure this accessory is of the type and design required
for use with your furnace.
The DVCF40XD model series with a single speed motor
is shown in the wiring diagram below. The required field
wiring connections are applicable to all models listed
above. For internal wiring connections to your model,
refer to the wiring diagram attached to the furnace.
COUNTERFLOW DIRECT VENT GAS WALL HEATER
25